DHL series electric boiler Introduction
DHL series bulk water tube is horizontal single drum water tube electric boiler, natural circulating water tube boiler, adopt flake type chain grate for preventing the leakage of coal, with stepless speed regulation of transmission device, around the boiler body was welded with membrane water wall tubes, the boiler design has air preheater with cast iron inside thread and outside fin to improve the thermal efficiency. Membrane wall adopt special composite silicate board as the cover and insulation layer, with insulation waterproof coating, control the boiler outer wall temperature below 50 C, for further increasing the thermal efficiency.
Product features:
1. Reasonable design “A-type" before and after arches, it can improve the ignition and combustion of coal. Reach the requirement of burning various coal. Combustion system is flake type chain grate, no leakage of coal. Rational design of heating surface, install economizer and air preheater at the back of boiler, in order to reduce the exhaust temperature and increase the air inlet temperature, efficient use of heat energy. Boiler water capacity is bigger, adapt bigger range of load change. Easy ignition, high temperature in boiler furnace, superior insulation performance, better burning of coal, coal ash carbon content below 10%, high thermal efficiency, with overload capacity, normally overload 10% in lower-elevation area. Adopt light boiler wall, no steel frame structure. The total weight is low, only half weight of the same model of bulk boiler, reduce the investment for boiler house. Corner tube boiler adopts modular design concept, water pipelines are big parts, assemble them on site, shorten the installation period. The boiler capacity and heating efficiency do not change with time being. It will bring big economic benefit.
Application fileds
Our oil/gas fired boilers can be divided into DHS series angle tube boiler,SZS water tube boilers and WNS fire tube boilers depending on the medium inside the tubes. With multiple pressure designs, the water tube boilers can meet the steam supply requirements of 2.5MPa or above. The fire tube boilers, on the contrary, are intended for use at pressures below 2.5 MPa. Fire tube boilers usually have a capacity of below 20t/h, while water tube ones of 20t/h or more as capacity expansion is possible.
The three series are designed with large furnaces, the thermal efficiency is over 98%, and the NOx emissions are as low as 30mg/Nm3. The front and rear smoke boxes are all equipped with a unique sealing structure to ensure that the smoke box does not leak smoke. At the same time, it has the characteristics of fully automatic and safe operation.
Quick Contact